Evaluation of the Some Mechanical and Surface Properties of Denture Base Materials Fabricated by 3D-Printer when Provided of ZrO2 and TiO2 Nanoparticles: Systematic Review in Vitro Studies

Ramadhan Ibrahim And Yousif Jabbar Al-Timime, Ali

doi:10.36582/ksj.2025.190267

Evaluation of the Some Mechanical and Surface Properties of Denture Base Materials Fabricated by 3D-Printer when Provided of ZrO2 and TiO2 Nanoparticles: Systematic Review in Vitro Studies

Document Type : Original Article

Author

Ali Ramadhan Ibrahim and Yousif Jabbar Al-Timime

https://doi.org/10.36582/ksj.2025.190267

Abstract

Integrate dentistry and informatics have emerged in the emergence of a new technology like 3d
printing.
The objective of the study was to evolve the effectiveness of nanoparticles on some important
mechanical properties for the base of denture which is made by 3d printing. The procedure of
work was first collected and analyzed, and relevant articles were chosen, the general databases
were searched for articles published that appeared between 2010 and 2024, and we grouped
relevant search terms, such as 3D-printer denture base, nanoparticles, mechanical test This
review was develop using the literature search was performed with PubMed/MEDLINE, Web of
Science and EMBASE databases, until 30 June 2024.
Printing resin presented the values of the flexural strength, tensile, and impact strength were
improved by addition with a limited concentration of ZrO2 and TiO2 compared between them
while indirect tensile and hardness appeared different results. The roughness does not appear any
different value.

Keywords

Three-dimensional print

Flexural strength

hardness